Let me play among the stars"
"It's cold outside, there's no kind of atmosphere"
A place of resource for Plumbers and Gas Engineers in the UK.
When starting out with solvent I used a marker pen to draw a line across the 2 pieces at the joint then removed it when the job was done. No need on a straight connector though
Ah, most pushfit around here and common.Mr KJ wrote: ↑May 5th, 2017, 9:50 pmSolvent all day long.
The problem with push fit is over time the ring seal compresses and loses its tightness. Added to expansion and contraction its an accident waiting to happen.
Plus if anyone uses a plunger to clear a clog they can blow off the pipe.
Sent from my SM-G920F using Tapatalk
If you have leaks on solvent weld joints then something is very wrong and as you have found out trying plaster to seal the joint will not work. Time to start again from the beginning.
Have you used the correct solvent to bond the pipe surface to the fittings?jack wrote:hello,
I have use solvent weld wastes but leakage problems and I have covered all area of the weld with plaster but not any result
can you help me?
Hi everyone, I recently bough a house in Cambridg[…]
Hello, I'm a 31 years old, and i'm in the middle[…]
Hi By Best. Thank you for the advice. Really appre[…]
Hi Kaz have you unscrewed these caps? .....being i[…]