UK Plumber Forum 

A place of resource for Plumbers and Gas Engineers in the UK.

Ask your general plumbing questions here. Please have a quick check to make sure it wouldn't fit in any other category.
By ryanTucker
#8337
Hey guys. I have a bit of an issue with my push button valve cistern flush. Basically when I flush it flushes fine but the plastic in the valve unit remains up and doesn't push back down on the rubber valve to stop the water running. If I take the cap off I can gently push the plastic down which pulls on the cable and returns it to it's proper position to stop the water running. Anyone have any idea on what I can do, the cable is in good condition, I am not sure if it is a fault in the valve unit of or they is a way I can improve the cable tention to push it shut. I thought about putting a weight on top of the plastic so there is a pressure pushing down on it to help it return to it's normally position but this is obvs a bit of a bodge.

Any help would be mega

Thanks

Ry
Spinning Tap

hi, you need to use photo-bucket to attach photo's[…]

101% of the time I've found replacing the https[…]

lanky rad

3;1 its leaked since posting haha

cheap lipo suction lol whats it doing blocking at […]