Page 1 of 1

squeeze off tool on 15mm plastic

Posted: October 22nd, 2018, 8:59 pm
by reacher
Can anyone tell me is it possible to squeeze off or clamp off 15mm plastic pipe to move a radiator to save draining off the system without damage to the pipe
cheers

Re: squeeze off tool on 15mm plastic

Posted: October 23rd, 2018, 7:35 pm
by TURNPIN
What make of pipe ...hep2o speedfit check the relevant website.....also check for possibility of freezing the pipe....regards Turnpin :D

Re: squeeze off tool on 15mm plastic

Posted: October 23rd, 2018, 8:15 pm
by reacher
ok i will check on the make of pipe, didn't think of freezing it that's a possibility cheers

Re: squeeze off tool on 15mm plastic

Posted: October 24th, 2018, 10:47 pm
by Best
I would just drop the pressure if a sealed system, or on an open vented system I would bung the feed and vent.
Plastic is going to be push fit or compression, so should be easy.

Re: squeeze off tool on 15mm plastic

Posted: November 9th, 2018, 1:02 am
by REDSAW
reacher wrote:
October 22nd, 2018, 8:59 pm
Can anyone tell me is it possible to squeeze off or clamp off 15mm plastic pipe to move a radiator to save draining off the system without damage to the pipe
cheers
jgspeedfit- no problem as said just back of pressure a bit.