UK Plumber Forum 

A place of resource for Plumbers and Gas Engineers in the UK.

For when your troubles just won't soak away, sort out your drainage issues in here.
By Apollo
#8342
I have a Polypipe UG502 drain cover and frame on my driveway. The Polypipe frame fits snugly into a 320mm dia chamber.

Whilst it's strong enough to withstand the occasional car tyre, I have had to replace the plastic cover twice recently due to damage from a car tyre pressing a stone through it (I have a gravel driveway). As you can't buy the cover without a new frame, this is proving expensive.

I'd therefore like to upgrade to a ductile iron cover and have been looking at the Clark Drain CD 1649KMB (as it's a LOT cheaper than the Polypipe equivalent). I realise that I will have to change the frame too, but have a question about sizing. Clark Drain state that their frame fits a 300mm chamber. However, they also state that it is compatible with their PPIC bases and risers, all of which are quoted as 320mm diameter.

I'm wondering if the "300mm" quoted by Clark Drain is just a nominal size and whether their frame would be compatible with my 320mm inspection chamber? If anyone with experience of such things has any advice, I would be very grateful.
User avatar
By REDSAW
#8343
why not just put a 4mm steel plate over the top 3'' bigger diameter? cheeper and easier to do.
User avatar
By REDSAW
#8346
that type is not designed for trafic only pedestrian use. the pot will not be supported either so a vehicle loading will cause problems. it needs bridging with steel cover plate or council type 2x2 slab then cover gravel over it!

320 into 300 does not go unless the supplier guarntees it will & offer return refund.

https://plasticsuppliesdirect.co.uk/und ... 320mm.html

Well, i would have said thermal expansion as it be[…]

Thank you REDSAW for your timely and helpful comme[…]

Hi all A few months into a new rental within a la[…]

same as any toilet installation. fit as 100% to wi[…]